Neulog Conductivity Sensor NUL-215
The Conductivity Sensor is based on a probe with two flat electrodes with known surface area and distance between them.
This logger sensor is based on a probe with two flat electrodes with known surface area and distance between them. A signal is supplied to the electrodes and by testing the signal behavior, the conductivity of the solution is calculated.
The logger sensor has three ranges for displaying the solution conductivity:
μs/cm – micro Siemens per centimeter
mg/L – milli gram per Liter
ppm – part per million
Experiment Duration: 1 second to 31 days.
Range and operation modes:
0-2000 μs/cm - 0.1 μs/cm Over 2000 - 1 μs/cm
0-1000 mg/L - 0.1 mg/L Over 1000 - 1 mg/L
0-1000 ppm - 0.1 ppm Over 1000 - 1 ppm
Max Sample Rate (S/sec): 100
ADC resolution: 17 bit
A connection between your sensors and hardware is required. You can choose from the USB Module, Wifi Module, RF Module, or Display Module. A Battery Module is also required for any connection other then USB Module, which is powered through the cable.
Products being sold are not toys. They are for Educational / Laboratory use only. They are not for use by children 12 and under.
Conductivity - Neulog logger sensor